PWM Pulse Width Modulator for HHO Hydrogen Cell 30 amp

If you are building a Hydrogen Generator cell, then you will need this electronic unit for best production and best operation, instead of letting your cell draw too much current. This unit will allow you to control Input current up to 30 amp. This unique design uses PULSE-WIDTH MODULATION & HIGH FREQUENCY to break down the water easily. This unit will not over heat your Hydrogen Generator.

Use this 30 Amp PWM Control module to control your Hydrogen Cell.

This is a small assembled device with an on-board trim pot to control the pulse width modulator output. Keep in mind that you should determine how hot the unit gets. If it gets to hot it will fail, in order to be able to carry high amperage for extended periods of time you will need to provide additional cooling. The unit will carry up to 30 amps. Use common sense when powering large loads.
Power Supply: 12 or 24 Volts DC (Car Battery OK)
Load Voltage: 12/24VDC 30 AMPS
Output Frequency: 400 Hz
Output Power is Adjustable from 0% to 100%, or anything in between. ( Perfect to control just the right amount of Hydrogen Production )
PCB Dimensions: 3.85 x 1.59


CONNECTING AND OTHER SPECIFICATIONS

POINT + 12 V is connected to the positive pole of the power supply 12VDC (+ of car battery)

POINT + M is connected to the positive pole of . Hydrogen Cell.

POINT - M is connected to the negative pole of the . Hydrogen Cell.

POINT G is to be connected to the negative pole of the power supply. (- of car battery)

VR 10K is used to adjust the speed of the Hydrogen Cell.

J is used to select the power supply 12v or 24VDC for the Hydrogen Cell .

Info by : Ebay